TPARTS Tempered Glass Screen Protector
Installation Guide

Follow the steps below for a perfect, bubble-free installation.

Installation Guide Video

Step-by-Step Instructions

Step 1: Enable screen clean mode
1

Enable the screen clean mode on your device to maximize screen brightness, making dust and fingerprints easier to spot before installation.

Step 2: Clean dust and fingerprints
2

Use the included screen cleaner to carefully wipe away any dust, fingerprints, and smudges. Ensure the screen is completely clean before proceeding.

Step 3: Secure the positioning frame
3

Align the positioning frame over your screen and press down firmly on all four corners to lock it in place. The frame ensures perfect alignment every time.

Step 4: Pull the tab
4

Hold the top edge of the positioning frame steady, then pull the release tab slowly and evenly to lay the tempered glass down onto the screen.

Step 5: Wait for adhesion then release buckle
5

Wait a moment for the tempered glass film to fully adhere to the screen surface. Once settled, release the side buckle to free the frame.

Step 6: Remove frame and protective layer
6

Carefully lift off the positioning frame, then peel away the surface protective layer. Your screen protector is now fully installed!

💡
Tip: If bubbles appear, gently lift the corner nearest to the bubble and allow the glass to re-adhere naturally — no pressing needed.

© TPARTS — Precision Tempered Glass Protection